DriveControl 54

Control of RollerDrive EC310 in applications without start-stop operation, e.g. in roller curves. Mechanical engineering applications. Applications with PLC, but without fieldbus. Small applications with max. 10 RollerDrive (cabling effort). Applications with anticipated splashing water or sprinkler system. Applications in freezer area.

The DriveControl 54 is a simple control for the RollerDrive EC310. It does not contain any logic (e.g. for zero-pressure accumulation conveying) and requires external signals. The DriveControl 54 has a protection rating of IP54 and, as a result, is suitable for use in wet environments or freezer conditions.

DIP switches can be used to set the direction of rotation, a start and braking ramp and the speed in 15 increments. Digital inputs and outputs serve as interface to a higher-level control. This enables setting the direction of rotation and the speed in 7 increments, e.g. from a PLC. The braking energy of the RollerDrive EC310 is fed back into the 24-V supply system. The voltage fed back from the RollerDrive EC310 is limited at 30 V by means of the integral brake chopper (voltage-dependently switched load resistance).

  • Speed setting (DIP switches 15x, digital input 7x)
  • Speed setting (DIP switches 15x, digital input 7x)
  • Error signal output
  • Status display with LEDs
  • Voltage limitation via brake chopper